The raising and lowering of the sample is controlled by a stream of pressurized air. Before placing a sample onto the top of the bore, make sure that the air flow is present (it is quite audible) and remove any sample which may be rising to the top of the bore.

1. Click on the Acquire tab in the Workflow tab bar.

2. Click on the down arrow inside the Sample button in the Workflow button bar.

3. Select Turn on sample lift air (ej) by clicking on it.

4. Place the sample plus the spinner on to the top of the magnet bore.

5. Click on the down arrow inside the Sample button in the Workflow button bar.

6. Select Turn off sample lift air (ij) by clicking on it.